NEW17
Doc: PIS - Aquavalve 3.0.doc
Page 1 of 5
PRODUCT
INFORMATION
LEADERS IN MARINE COMPOSITE FITTINGS
AQUAVALVE
The Tru-Design Aquavalve is the most versatile valve on the market today. The Aquavalve is
designed and made in New Zealand, for demanding marine sanitation applications.
The Aquavalve is typically used in marine toilet applications where protection for the environment
necessitates the need to control effluent discharge – in many countries this is governed by
regulation. The effluent can be held in a holding tank for later discharge overboard or to a shore
side facility.
The Tru-Design Aquavalve is moulded from a glass reinforced nylon composite. High strength,
high-modulus glass fibres impregnated into the nylon provides dramatic strength, stiffness,
toughness, and dimensional stability.
MODELS
Part #
Description
90314
Aquavalve White
90312
Aquavalve Black
New
Products
BALL VALVE and POSITION MONITORED BALL VALVES - DIMENSIONS
Doc: PIS - Ball Valve 3.1.doc
Page 3 of 6
LEADERS IN MARINE COMPOSITE FITTINGS
SPECIFICATIONS
The connecting threads on each end of our ball valves are BSP (British Standard Pipe) and are
parallel. These parallel threads are designed so that thread tape is wound onto a male skin fitting
or tail then screwed into the ball valve. The advantage of parallel threads rather than tapered is
that there is maximum engagement between the mating threads providing a strong and watertight
seal.
Mixing parallel and tapered threads can cause strength and sealing problems as the engagement
can frequently be only a few turns.
DIMENSIONS
All dimensions in mm.
All dimensions nominal.
19
mm – ½” BSP, ¾” BSP, 1” BSP
Doc: PIS - Ball Valve 3.1.doc
P
INFOR
LEADERS IN MARINE COMPOSITE FITTINGS
32
mm – 1¼” BSP, 1½” BSP
19 - 1/2"
N S, 3/4" NPS, 1" NPS
- -1/4"
N S, 1-1/2" NPS