![]()
77
Wema tank sensors for fuel and water are used by prestigious yachts
and trucks worldwide, such as Halberg Rassi, Nimbus, Hunter, Fairline, Janneau, Broom, Windy,
Sea-Ray, Ta Shing, Silverton, Baltic Yachts, Najad, Pedrobout, Man, Volvo etc. etc.
SUITABLE FOR REPLACEMENT ON MOST GAUGES
STAINLESS FUEL/WATER SENSOR
Fuel or Water Sensor with 1 1/4" BSP thread. Type
316 Stainless Steel.
Requires WMFL-2WE Mounting
flange, to be ordered separately
. Separate flange
means that sensor can be easily removed from tank if
required, or sensor can be threaded directly into a tank
that already has a threaded fitting.
Available in Lengths from 4" to 60" in 1" increments.
240 Ohms - 30 Ohm.
Constructed to meet and/or exceed all applicable ISO,
NMMA/ABYC and USCG standards.
WMS3U-
##
##
= Length in Inches
i.e. WMS3U-16 is a 16" sensor.
TOP FLANGE AND UNDER-FLANGE
WMFL-2WE
Required for
WMS3U Sensors
WMFLS-U
Stainless steel under flange, including stainless screws.
Used to fit inside the tank in connection with WMFL-2WE.
Recommended for new installations. 2-3/8" hole required.
WMFLS-U
The reasons are obvious:
• No moving parts to give trouble.
• Very easy to install.
• Long term reliability under severe conditions.
• Fully insulated, no electrolytic corrosion.
• Approvals in North America and Europe (Certificate on request).
Approved by
Veritas, Imanna Labs
Sensor threads into mounting adapter, for easy removal for
cleaning. Mounting adapter and unders ring are made for
safe and easy installation in any holding tank. 316SS.
1 1/2" NPT Thread. 240 Ohm - 30 Ohm.
WMSHS-4
4"
WMSHS-16
16"
WMSHS-8
8"
WMSHS-20
20"
WMSHS-12
12"
STAINLESS STEEL HOLDING TANK SENSOR
WITH MOUNTING ADAPTER AND UNDER-RING
2 3/16"
LENGTH
TANK SENSORS
Wema supplies the most reliable tank sensors available on the market. The sensors are fully
insulated to protect against dangerous voltage inside the tanks. This is an extremely important safety
feature, because it protects against electrolytic corrosion on engines etc., and explosion danger.
WATER SENSOR
Sensor for Water Only. With 1 1/4"BSP thread. Made of
ABS Plastic.
Requires WMFL-2WE Mounting flange,
to be ordered separately
. Separate flange means that
sensor can be easily removed from tank if required, or
sensor can be threaded directly into a tank that already
has a threaded fitting.
Sizes currently available: 6", 22"
WMWU-06
6"
WMWU-22
22"
For Water Only.
Limitied Quantities
and Sizes
WMFL-2WE
Standard flange, used to mount the stainless water/fuel sen-
sor in the tank. Nitrile rubber gasket included. Diam. 80mm(
3.2"). With American SAE - 5 Hole mounting pattern, and
European Standard mounting pattern.
WMFL-2WE
Mounting flange for water sensor, Nitrile rubber
gasket included. Diam. 80mm( 3.2")
